Company brochure
Jcsmusical's Blog
Just another WordPress.com site
Archive for the ‘ Guitar building ’ Category
Inlay material, side marker special
http://astore.amazon.com/jcsmusins-20?_encoding=UTF8&node=57
FREE SHIPPING!!
K) BEST VALUE! (VARIETY 8 PACK) 7″ rods.
4 of the 3/32″ (2 black, 2 white)
4 of the 1/16″ (2 black, 2 white)
<a href=’http://www.siteprice.org/website-worth/www.jcsmi.com’><img border=’0′ alt=’Buy Websites’ title=’Buy Websites’ src=’http://www.siteprice.org/widgets/j/jcsmi.com.png’/></a>
2012 in review
The WordPress.com stats helper monkeys prepared a 2012 annual report for this blog.
Here’s an excerpt:
The new Boeing 787 Dreamliner can carry about 250 passengers. This blog was viewed about 1,800 times in 2012. If it were a Dreamliner, it would take about 7 trips to carry that many people.
Stage 18) Final sanding.
I like to use slightly worn 150 grit 3M sand paper to sand all sharp corners on the headstock and heel of the neck. Then the back of the neck and top face of the headstock. Use your hand so you can get a feel for the surface of the wood. Try using a sanding sponge block on the edges if over 150 grit. When the neck feels and looks scratch free, the neck is ready for finishing.
Stage 17) Drilling the tuner holes.
Using a template with the center lines for the tuner key locations, pencil the center point of the holes onto the headstock. Next, set up the drill press with the recommended drill bit for the tuners recommend size. Make sure to use a brad point drill bit to get the cleanest cut at the top face and back of the hole. Next, we need to have a backing plate of wood to put behind the headstock so the drill bit does not tear out the grain on the back side of the headstock. After all holes are drilled, block sand top and back with 150 grit 3M sanding paper.
Stage 16) Nut work
Check out the video below to get all the details on stage 17.
WATCH SAMPLE HERE!
Nut Making
Watch as a nut is processed and shaped from a bone blank to a semi-gloss nut.
Stage 15) Fretting the neck
Get this portion of the instructional below.
WATCH SAMPLE HERE!
Fretting Necks: LEARN THE TECHNIQUES INVOLVED in FRET BENDING, CUTTING, INSTALLING, SHAPING,
BRINGING FINISHED FRETS TO A HIGH LUSTER AND MORE AT JCS MUSICAL
INSTRUMENTS.
Information
Change this sentence and title from admin Theme option page.
Blog Stats
- 11,588 hits
JCSMI Hot Rodded Guitar Parts
| M | T | W | T | F | S | S |
|---|---|---|---|---|---|---|
| 1 | 2 | 3 | 4 | |||
| 5 | 6 | 7 | 8 | 9 | 10 | 11 |
| 12 | 13 | 14 | 15 | 16 | 17 | 18 |
| 19 | 20 | 21 | 22 | 23 | 24 | 25 |
| 26 | 27 | 28 | 29 | 30 | ||
Join 2 other subscribers
Jcsmusical's Blog 
